Abstract - The Optimization of Granite Powder and its effect on fresh and hardened properties of Ready Mix Concrete with partial replacement to Cement were investigated. Mix design of M20 Grade was done according to Indian Standard Code IS 10262:2009 using Granite Powder and Manufactured Sand.

The powder of granite and glass are been used as a construction material to reduce the environmental problems. II. SCOPE AND OBJECTIVE A. Objective The objective of this project is to investigate the development of Concrete Strength using glass powder as a partial replacement for cement and granite powder for fine aggregate.

percentage of Granite waste Powder is added with the partial replacement to cement in mortar cubes & Concrete. In this experimental study, granite waste powder was used in concrete as a cementations material as partial replacement of cement. Replacement of cement was made by level of 10%, 12%, 14%, 16%, and 20%.

Felixkala.T et al., (2010) concluded that the study on the performance concrete made with granite powder as fine aggregate and partial replacement of cement with 7.5% Silica fume, 10% fly ash, 10% slag and 1% super plasticiser subjected to water curing is

In thi s in vestigation Granite Slurry (GS) was used as partial substitute in proportions varying from. 5% to 20% by weight to cement in concrete and tested for compressive strength, tensile ...

Experimental Investigation on Partial Replacement of Cement Use Only by Granite Powder and Addition of Coir Fiber as Admixture Aravind A1, Sundari S2 P.G. Student, Department of Civil Engineering, Government College of Engineering, Salem, Tamil Nadu, India1

The partial replacement of glass powder as fine aggregate Makes the concrete strengthen. Thus our project states that concrete can be strengthen by glass powder replacement, which makes the waste in to useful, so the waste materials made in to use.

This granite powder waste can be utilized for the preparation of concrete as partial replacement of sand. In order to explore the possibility of utilizing the granite powder as partial replacement ...

In this thesis OPC-43 grade cement is replaced partially by stone dust & granite powder simultaneously in the proportion of 5%, 10%, 15% & 20% by weight. Mortar cubes were casted, tested and compared in terms of compressive strength to the standard mortar mixtures.

percentage of Granite waste Powder is added with the partial replacement to cement in mortar cubes & Concrete. In this experimental study, granite waste powder was used in concrete as a cementations material as partial replacement of cement. Replacement of cement was made by level of 10%, 12%, 14%, 16%, and 20%.

Partial Replacement of Sand with Quarry Dust in Concrete. -The reduction in the sources of natural sand and the requirement for reduction in the cost of concrete production has resulted in the increased need to identify substitute material to sand as fine aggregates in the production of concretes especially in Concrete.

In the present work, the cement by partial replacement with granite powder in normal state and calcined state up to 50% and the compressive strength of cement paste is found at 28 days. The results indicate that the partial replacement of cement with granite powder results in only a 10% decrease in strength when

of using granite powder as replacement of sand and partial replacement of cement with fly ash, silica fume, slag and superplasticiser in concrete. The percentageof granite powder added by weight was 0, 25, 50, 75 and 100 as a replacement of sand used in concrete and cement was replaced with 7.5% silica fume, 10% fly ash, 10% slag and

This paper examines the possibility of using granite powder as replacement of sand and partial replacement of cement with fly ash, silica fume, slag and superplasticiser in concrete. The percentage of granite powder added by weight was 0, 25, 50, 75 and 100 as a replacement of sand used in concrete and cement was replaced with 7.5% silica fume ...

PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST POWDER Prof. P.A. Shirule a*, Ataur Rahman b, Rakesh D. Gupta c Address for Correspondence a*bc Dept. Of Civil Engineering, SSBT's COET, Bambhori, Jalgaon, Maharashtra – 425001 ABSTRACT Leaving the waste materials to the environment directly can cause environmental problem.

in present study the detailed characteristic studies of concrete is carried out by partial replacement of natural sand by waste granite powder in concrete composition with different percentages (0%, 10%, 20%, 30%, 40%, 50%).the mechanical properties of concrete like compressive strength, tensile strength are carried out by replacing the quantity …

N.Elangovan, D.Sri Ruban "Flexural Behavior of Concrete by Partial Replacement of Cement, Fine Aggregate by Glass Powder and Granite Powder", International Journal of Engineering Trends and Technology (IJETT), V46(4),184-189 April 2017. ISSN:2231-5381. published by seventh sense research group. Abstract Most of the glass sheet cutting industries was not properly …

1) Srinivasa. C. H., Dr. Venkatesh " Optimization of granite powder used as partial replacement to cement in the desigh of ready mix concrete of M20 grade using IS10262:2009", Journal of engineering research & technology. Vol. 4 (2015) 2) G V Vigneshpandian, E Aparna Shruthi, C Venkatasubramanian, D Muthu "Utilisation of waste granite

[2] M.ThanigaiSelvan, ―Utilization of granite powder waste as fine aggregate in high performance concrete‖, International Journal of Engineering Research and Advanced Technology, Vol 2 (2),46-65, 2014. Partial Replacement (Marble Dust & Kota Stone Chips) Compressive Strength (N/mm2) 7 Days 14 Days 28 Days 0% 22.44 29.06 30.13

In present study the detailed characteristic studies of concrete is carried out by partial replacement of natural sand by waste granite powder in concrete composition with different percentages (0%, 10%, 20%, 30%, 40%, 50%).The mechanical properties of concrete like compressive strength, tensile strength are carried out by replacing the ...

Partial Replacement of Cement in Concrete with Granite Powder and Fine Aggregate with Saw Dust Ash and Quarry Dust by M. Jagadeeshwaran after review is found suitable and has been published in Volume 9, Issue X, October 2021 in International Journal for Research in Applied Science & Engineering Technology Good luck for your future endeavors

Pillai G.G., Mathew M. (2021) Effects of Eggshell Powder and Granite Powder on the Strength Properties of Concrete by Partial Replacement of Cement and Fine Aggregate. In: Singh R.M., Sudheer K.P., Kurian B. (eds) Advances in Civil Engineering. Lecture Notes in …

Figure 5.3 Flexure Strength of Different Mix of M-30 Concrete (with Fly ash 10% & Cement 90%) 5.6 SPLIT TENSILE STRENGH TEST The result of the split tensile strength with partial replacement of Granite powder and without using fly ash for 7, 14 and 28 days are shown in the Table 5.15 for M-30 concrete and their graphical representation in the M ...

Granite Slurry for Partial Cement Replacement in Concrete: A Review Gaurav Sharma1, ... powder when comes in contact by breathing causes respiratory problems to the human beings. Under the action of winds it floats and rests on the plants leafs and crops, where it affects their growth. Therefore this granite

tests on granite powder as a partial sand replacement in high perfor-mance concrete and showed the beneficial effects on its mechanical properties. Of all the six mixtures he considered, concrete with 25% of granite powder (GP25) was found to be superior to other percentages of granite powder concrete as well as conventional. Prabhu et al. [6]

C305. The percentages of cement replacement by weight with (LNP) powder were 10%, 20%, 30% and 40%, the percentages of partial replacement of sand by volume with (LNP) were 10%, 20%, 30% and 40% and the percentages of cement replacement by weight with silica fume were 0%, 5% and 10%. Figure- 3 shows part of specimens after molding and before ...

waste can be utilized for the preparation of concrete as partial replacement of sand. In order to explore the possibility of utilizing the granite powder as partial replacement to sand, an experimental investigation has been carried out. The percentages of granite powder added to replace sand by weight were 0, 5, 10, 15, 20 and 25.

Experimental study of concrete made with granite and iron powders as partial replacement of sand The percentages of GP and IP added to replace sand were 5%, 10%, 15%, and 20% of the sand by weight. Singh et al. [16,17] suggested that 2540% of river sand can be substituted by the granite cutting waste (GCW) with a favorable influence on the

The main objective of this experimental work was to investigate the shrinkage properties of concrete made with granite powder as fine aggregate and partial replacement of cement with combination of admixtures. The granite powder, one of the byproducts in stone crushing process, not being used for any applications other than filling-up low lying ...

An experimental study on high-performance concrete made with granite powder as fine aggregate and partial replacement of cement with admixtures subjected to water curing was carried out. The percentage of granite powder added by weight was 0, 25, 50, 75 and as a replacement of the sand used in concrete and cement was partially replaced ...

Partial replacement of marble powder in cement accordingly in the range of 20%, 30%, 40%, by weight for M20 grade of concrete. With this experimental research work the problem of waste production management of this agro waste are will be solved.

Sustanable And Cost Effective Building Material Technology The Optimization of Granite Powder and its effect on fresh and hardened properties of Ready Mix Concrete with partial replacement to Cement were investigated. Specimens were tested for evaluation of optimum percentage of Granite Powder in Ready Mix Concrete for Compressive Strength.